Chain Link Fence

Description

Woven wire usually made from galvanized or PVC coated galvanized steel wire. The wires run vertically and are bent into a zig-zag pattern so that each "zig" hooks with the wire immediately on one side and each "zag" with the wire immediately on the other. This forms characteristic diamond pattern seen in this type of fence.

Fabric with 2-in. [50.8mm] or 2-1/8-in. [54.0-mm] mesh, in heights less than 72 in [1829 mm], shall be knuckled at both selvages. Fabric 72 in. [1829 mm] high and over shall be knuckled at one selvage and twisted at the other. These are standard selvages. Other selvage combinations will be supplied only if specified by the purchaser.

Usually selvages for fabrics less than 2-in. [50.8mm] shall be knuckled at both edges.

Mouseover to view image

Line Wire is used to secure fence fabric.

View Line Wire Images

To secure fence fabric to line wire.

View Tie Wire Images

View Stirrup Wire Images

Description

Typically made out of 25x5mm thick MS flat bars weaved through end mesh and secured after stretching the fabric at strainer posts.

View Stretcher Bar Images

Description

Mild steel tubes, Galvanized or powder coated, placed usually about Three(3) meters from each other to support the fence, in variety of diameters (usually around 42mm to 60mm) and wall thickness.

Mouseover to view image

Description

Usually used either at ends of a chain link fence, or where the fence bends or at suitable distances (usually around 30 meters) when the fence is running in straight line for long distances.

Description

Mild steel tubes, Galvanized or powder coated, with variety of diameters (typically between 48mm and 89mm) and wall thickness.

View Straining Post Images

Description

Usually used either at ends of a chain link fence, or where the fence bends or at suitable distances (usually around 30 meters) when the fence is running in straight line for long distances.

Description

Mild steel tubes, Galvanized or powder coated, with variety of diameters (typically between 48mm and 89mm) and wall thickness.

View Corner Post Images

Description

Usually used either at ends of a chain link fence, or where the fence bends or at suitable distances (usually around 30 meters) when the fence is running in straight line for long distances.

Description

Mild steel tubes, Galvanized or powder coated, with variety of diameters (typically between 48mm and 89mm) and wall thickness.

View End Post Images

Description

Mild steel tube, galvanized or powder coated, fixed horizontally between Straining post and Intermediate post. The End/Corner/Straining posts are under stress from the stretch of chain link fence fabric. The horizontal support or brace helps spread the stress out over both the terminal post and the next intermediate post in line.

Commonly used diameters are around 42mm to 48mm.

View Horizontal Support Images

Description

Installed at bottom of a terminal post (end/straining or corner post) to the two-third height of the adjacent intermediate post, pulls the horizontal support/brace towards the terminal post, in the process counteracts the pull from the stretch on the chain link fabric.

It is threaded at one end. Commonly used diameters are around 10mm. Length depends upon the distance between the straining post and the intermediate post.

View Truss Rod Images

Horizontal member of the framework running from terminal post to terminal post on top of the line posts.